Helps you easily make overcasting with a piping width less than 7mm. Can use straight stitch Zigzag stitch or decorative stitch.
1. Before installing the presser foot. Please insert the piping strip into the guide groove of the presser foot. Make sure the edge of the piping aligns with the guide groove of the presser foot.
2. Pull out the piping strip from the back of the presser foot.
3. Install the presser foot.
4. Adjust the needle position until the needle drop point is at the edge of the piping.
Tip If the needle cannot be adjusted to the proper position on the binding edge you can loosen the screw on the presser foot move left and right to adjust the position of the guide groove.
